History

Peter Johanson 35a1c5a3d4 refactor(behaviors): Rename `reset` behavior. * Upstream now has a node w/ label `reset` on many boards, so renaming our reset behavior node label to `sys_reset`.		2023-04-05 22:55:38 -07:00
..
Kconfig.defconfig	…
Kconfig.shield	…
README.md	…
cradio.conf	…
cradio.dtsi	…
cradio.keymap	refactor(behaviors): Rename `reset` behavior.	2023-04-05 22:55:38 -07:00
cradio.zmk.yml	…
cradio_left.conf	…
cradio_left.overlay	…
cradio_right.conf	…
cradio_right.overlay	…

README.md

Cradio

Cradio is a firmware for a few 34 key keyboards, including Cradio, Hypergolic and Sweep.

Pin arrangement

Some revisions of the aforementioned PCBs have slightly different pin arrangements compared to what's defined in cradio.dtsi. If you need to swap a few keys for your particular PCB, you can easily reorder the input-gpio definition in your own keymap file (i.e. in zmk-config/config/cradio.keymap):

/* Adjusted Cradio pin arrangement */
/* The position of Q and B keys have been swapped */
&kscan0 {
	input-gpios
	= <&pro_micro  6 (GPIO_ACTIVE_LOW | GPIO_PULL_UP)>
	, <&pro_micro 18 (GPIO_ACTIVE_LOW | GPIO_PULL_UP)>
	, <&pro_micro 19 (GPIO_ACTIVE_LOW | GPIO_PULL_UP)>
	, <&pro_micro 20 (GPIO_ACTIVE_LOW | GPIO_PULL_UP)>
	, <&pro_micro 21 (GPIO_ACTIVE_LOW | GPIO_PULL_UP)>
	, <&pro_micro 15 (GPIO_ACTIVE_LOW | GPIO_PULL_UP)>
	, <&pro_micro 14 (GPIO_ACTIVE_LOW | GPIO_PULL_UP)>
	, <&pro_micro 16 (GPIO_ACTIVE_LOW | GPIO_PULL_UP)>
	, <&pro_micro 10 (GPIO_ACTIVE_LOW | GPIO_PULL_UP)>
	, <&pro_micro  1 (GPIO_ACTIVE_LOW | GPIO_PULL_UP)>
	, <&pro_micro  2 (GPIO_ACTIVE_LOW | GPIO_PULL_UP)>
	, <&pro_micro  3 (GPIO_ACTIVE_LOW | GPIO_PULL_UP)>
	, <&pro_micro  4 (GPIO_ACTIVE_LOW | GPIO_PULL_UP)>
	, <&pro_micro  5 (GPIO_ACTIVE_LOW | GPIO_PULL_UP)>
	, <&pro_micro  7 (GPIO_ACTIVE_LOW | GPIO_PULL_UP)>
	, <&pro_micro  8 (GPIO_ACTIVE_LOW | GPIO_PULL_UP)>
	, <&pro_micro  9 (GPIO_ACTIVE_LOW | GPIO_PULL_UP)>
	;
};

This &kscan0 block must be placed outside of any blocks surrounded by curly braces ({...}).